Used to loosen the slip nuts on the P-trap and the drain arm. A proper pipe wrench grips the nut without crushing the pipe.
Garbage Disposal Installation Lakeland FL Done Right
When your kitchen sink backs up or the disposal grinds to a halt, garbage disposal installation Lakeland FL homeowners trust starts with a proper mount, sealed drain connections, and wiring that meets code.
Serving Lakeland and nearby areas.
How big is the job?
Swap plus pipe
New disposal plus replacement of a corroded trap or drain stub.
- 1. Swap only Old unit out, new unit in, existing mount and wiring reused.
- 2. Swap plus pipe New disposal plus replacement of a corroded trap or drain stub.
- 3. Full rebuild New disposal, new drain connections, and a new dedicated circuit.
Drag the needle to compareTouch and drag the needle
- 30Services from one local team
- 20Areas served around Lakeland
- Test firstWe check wiring and pipes before we start.
- Leak checkEvery connection gets tested with running water.
What Is Included in a Disposal Install
Every garbage disposal installation we do includes the full scope below.
Work order
Garbage Disposal Installation- Old Unit Removal: We disconnect the old disposal, remove the mounting ring, and scrape the old putty and gasket off the sink flange. The old unit goes in the van and gets hauled away. You do not have to figure out how to dispose of it.
- New Mounting Hardware: We install a new sink flange, gasket, and mounting ring with fresh plumber's putty. Reusing old hardware is a common cause of leaks. New hardware costs a few dollars and saves a callback.
- Drain Connection: The discharge tube connects to your P-trap with new washers. We check the trap arm and the drain stub in the cabinet wall. If the pipe is corroded, we replace that section with new PVC pipe and pipe fittings.
- Electrical Connection: Hardwired units get a proper junction box connection with the correct wire nuts and a grounded circuit. Plug-in units connect to the existing outlet. We test the circuit with a voltage tester before and after.
- Leak Testing: We fill the sink, run the disposal, and run the dishwasher cycle if it drains into the disposal. Every connection gets checked with a flashlight and a dry paper towel. If we see a drip, we fix it before we leave.
- Haul-Away and Cleanup: The old disposal, the packaging, and any replaced pipe go with us. We wipe down the cabinet floor and the sink area. You should not have to clean up after a plumber.
What the first visit covers
First visit
We inspect the sink mount, the P-trap, and the wiring, then install and test the new disposal.
Disposal installation at homes
We install disposals in kitchens across Lakeland, from older bungalows to new builds.
Leaking old unit
We replace it and check the cabinet for water damage.
Jammed or dead motor
We install a new unit with a stainless steel grind ring.
Kitchen remodel
We add a disposal to a sink that never had one.
Customer-supplied unit
We install the disposal you bought and test it.
Disposal installation at businesses
We install and replace disposals in commercial kitchens and rental properties.
Restaurant kitchens
Heavy-duty disposals for commercial sink stations.
Rental properties
Fast turnarounds between tenants.
Office break rooms
Standard disposals for kitchenettes and break areas.
Garbage Disposal Installation Lakeland FL Explained
A disposal installed correctly lasts a decade. One installed with reused hardware leaks in months. We do the full job: new mount, sealed drain, tested wiring, and a dry cabinet when we leave.
Garbage disposal installation Lakeland FL is the removal of your old unit and the mounting, wiring, and drain connection of a new one under your kitchen sink. We cut the old disposal free, scrape the plumber's putty and old gasket off the sink flange, set a new flange with fresh putty, and bolt the disposal to the mounting ring. Then we connect the discharge tube to the P-trap, tighten every slip nut, and run water through the unit to check for drips at the flange and the drain arm.
Most Lakeland homes we service were built between 1950 and 2005, and the original sink drains often use 1.5-inch PVC pipe with a metal P-trap that has corroded. When we install a new disposal, we inspect the trap arm and the drain stub in the cabinet wall. If the pipe is soft or the trap is rusted through, we replace that section with new PVC pipe and pipe fittings while we are already under the sink. That saves you a second service call later.
- What it is
- Removal of the old disposal and installation of a new one.
- When it helps
- Leaks, jams, dead motors, or a kitchen remodel.
- What you get
- A working disposal, tested connections, and haul-away.
What to Expect During Installation
We keep the job simple and clean. Here is the five-step process we follow on every garbage disposal replacement and installation Lakeland, Florida job.
Tools and Methods We Use
Each method answers a different question. Together they leave very little to guess.
Checks that power is off at the disposal circuit before we touch any wiring. We test again after the connection to confirm the circuit is live and grounded.
Clears clogs in the branch drain when the sink drains slowly after a disposal install. We run it through the trap arm and into the wall stub.
Inspects the sewer lateral when we suspect a bigger blockage downstream. The camera shows root intrusion, collapsed pipe, or heavy grease buildup.
Used to splice in new pipe under the sink when the existing supply or drain line is corroded. These push-to-connect fittings seal without soldering.
When to Install a New Disposal
Your disposal is 10 to 15 years old and making grinding noises
We pull the old unit, inspect the sink flange and P-trap, and install a new 1/2 HP or 3/4 HP disposal with…
HomesYou are remodeling your kitchen and want a disposal added to a sink that never had one
We cut the drain line, install a new P-trap and discharge tube, and mount the disposal to the new sink flange.
HomesYour disposal leaked into the cabinet and you need it replaced before a family gathering
We offer same-day and next-day appointments for urgent replacements.
HomesYou bought a new disposal at a big-box store and need it installed
We install customer-supplied units. Bring the disposal and the mounting hardware from the box.
Homes
How Disposal Installation Works in Lakeland
Lakeland's housing stock ranges from 1920s bungalows in Dixieland to new construction in Christina. Older homes often have 1.5-inch galvanized or copper drain lines under the sink that have corroded over decades. When we install a new disposal in those homes, we inspect the trap arm and the drain stub.
Dixieland
Many homes here were built before 1950 and have original galvanized drain lines. We often replace the P-trap and drain stub during a disposal install.
South Lakeland
Newer construction with PVC drain lines. Disposal installs here are usually straightforward swaps with minimal pipe work.
Lake Hollingsworth
A mix of mid-century and newer homes. We see a lot of hard water scale in disposals and faucets in this area.
- Dixieland
- South Lakeland
- Lake Hollingsworth
- Downtown Lakeland
From problem to finished result.
Slide to compare the photo with an illustrative inspection view. It is generated from the photo, not a measurement.
PhotoLeaking Disposal in Dixieland Bungalow
Before: A 12-year-old 1/3 HP disposal was leaking from the bottom into the cabinet. The particleboard floor was soft and stained. The P-trap was rusted and the shutoff valve was frozen open.
After: We installed a new 1/2 HP disposal with fresh mounting hardware, replaced the P-trap with PVC pipe, and installed a new shutoff valve. The cabinet floor dried out and we sealed the wood. Total job time was two hours.
New Disposal for South Lakeland Kitchen Remodel
Before: A homeowner was remodeling their kitchen and wanted a disposal added to a sink that never had one. There was no outlet under the sink and the drain line had no trap.
After: We installed a new P-trap and discharge tube, mounted a 3/4 HP disposal to the new sink flange, and ran a dedicated 20-amp circuit from the panel. The job took about four hours.
Emergency Disposal Replacement in Lake Hollingsworth
Before: A disposal shorted out and tripped the breaker during a family dinner. The unit was 15 years old and the motor was burned. Water had leaked into the outlet box.
After: We replaced the disposal with a new 1/2 HP unit, replaced the damaged outlet with a GFCI, and dried out the cabinet. The job was done the same afternoon.
Problems We Solve With New Disposal Installs
Most disposal calls fall into a few categories. Here is what we see in Lakeland kitchens and how a proper installation fixes it.
Disposal hums but will not spin
A jammed flywheel burns out the motor if you keep hitting the reset button.
Leaking from the bottom of the disposal
A leak from the housing means the internal seal has failed.
Slow drain after installing a new disposal
A slow drain usually means the P-trap or branch drain is clogged with grease and food debris.
Disposal trips the breaker every time
A breaker that trips repeatedly points to a wiring problem, a bad outlet, or a motor that is drawing too many amps.
Why Upgrade Your Kitchen Disposal
A new disposal stops the daily annoyance of a jammed or leaking unit and protects your cabinet floor from water damage.
Stops Repeat Jams
Older 1/3 HP units jam on coffee grounds, eggshells, and fibrous vegetable scraps.
Protects Cabinet Floor
A leaking flange or cracked housing drips slowly into the cabinet base and warps the particleboard.
Quieter Kitchen
Budget disposals rattle the whole sink cabinet.
Code-Correct Wiring
Hardwired disposals need a proper junction box connection and a grounded circuit. Plug-in models need a dedicated outlet under the sink.
Garbage Disposal Installation Cost
That includes the unit, labor, new mounting hardware, and haul-away. If we find corroded pipes or need to run a new circuit, the price goes up.
Included
Quoted after a first look
- Old Unit Removal
- New Mounting Hardware
- Drain Connection
- Electrical Connection
What changes the scope
Quoted after a first look
- Disposal unit size and brand
- Mounting hardware condition
- Drain pipe condition
- Electrical work
What you receive
Clear records you can keep and share.
Written quote
The full job price before we start.
Install record
The model and serial number of your new unit.
Test results
Confirmation that every connection is leak-free.
16 Years Installing Disposals in Lakeland
Lakeland Swancrest Plumbing has been installing and repairing garbage disposals since 2010.
Mount condition
We check the sink flange and mounting ring for corrosion before reusing them.
Drain slope
We measure the discharge tube slope to ensure waste flows out of the cabinet.
Circuit load
We check the breaker size against the disposal's amperage draw.
Do we cover your street?
Type your ZIP code or town. If yours is not listed, call and ask.
Lakeland ZIP codes
- 33813
- 33803
- 33801
- 33805
- 33815
- 33811
- 33802
- 33804
- 33806
Towns we serve.
Based in Lakeland and covering the places around it. Pick one for local details.
What Lakeland Customers Say
Our old disposal was leaking into the cabinet and smelled terrible. The technician showed up the same afternoon, pulled the old unit, and found the P-trap was rusted through. He replaced the trap and installed a new 1/2 HP disposal in about two hours. Cleaned up everything and hauled the old one away. Fair price and no surprises.
I bought a disposal at the hardware store and needed someone to install it. Lakeland Swancrest came out the next morning and had it running in 90 minutes. They checked the wiring, tested for leaks, and showed me how to use the jam wrench. I appreciated that they did not try to sell me a unit I already had.
We had a disposal that kept tripping the breaker. The technician traced it to a loose connection in the junction box and fixed it while installing a new unit. He also replaced the corroded shutoff valve under the sink. Everything works perfectly now. I have used them twice and will call again.
Frequently Asked Questions
Short answers for the first few minutes. The team can cover the rest.
Still have a question?
Describe what you are seeing and we will point you to the right next step.
(863) 445-7111A basic 1/3 HP swap on an existing mount sits at the low end. A 3/4 HP unit with new mounting hardware, a replaced P-trap, or hardwired electrical work pushes toward the higher end. We quote the full job before we start.
Yes. We install customer-supplied disposals all the time. Bring the unit and the mounting hardware that came in the box. If the box is missing the flange, gasket, or discharge tube, we carry those parts on the van. We check that the unit matches your sink mount type before we start. Labor for a customer-supplied unit is the same as if we supplied it.
A standard swap takes 90 minutes to two hours. That covers removal, inspection, new unit install, wiring, and leak testing. If we find corroded pipes or need to run a new circuit, add 45 to 60 minutes. We do not rush the testing step, because a slow drip at the flange will rot your cabinet floor over time. You get a working disposal and a dry cabinet when we leave.
Yes. We install hardwired units that connect to a junction box under the sink and plug-in models that use a standard outlet. If your current setup is hardwired and you bought a plug-in unit, we can convert it. If you have a plug-in now and want a hardwired unit, we run the connection to code. We check the breaker size and grounding before we make any electrical connection.
Related Services
Other services from the same team.
- Garbage Disposal RepairA humming disposal that will not spin is usually jammed, not dead.
- Water Softener InstallationLakeland's hard water leaves scale in water heaters and fixtures.
- Water Softener RepairHard water coming back, salty-tasting water, or a unit that will not regenerate usually means a failed resin…
Get Your Garbage Disposal Installation Lakeland FL Today
(863) 445-7111Call (863) 445-7111 and we will schedule a same-day or next-day visit. We quote the full job before we start, haul away the old unit, and test every connection.
Call or message us
Call (863) 445-7111 any time for emergency plumbing, or send a message and we will get back to you the same business day. Our office is open Monday through Friday, 8 a.m. Tell us what you are seeing and we will tell you what it likely is and what it takes to fix it.